Commander12 Gen2 remote controlled relay box

Commander12 Gen2 lets you switch on and off LED bars, auxiliary lights, work lights, etc. and turn on and off other devices at the touch of a button! 2nd generation Commander is upgraded with a memory that remembers your settings even after you turn off the ignition/vehicle.

Note: The video below shows Commander8, which has 8 outputs, but with the same functionality as Commander12.

Programmable control panel with 12 individual outputs, controls up to 12 units separately or together. A control with RGB selectable backlight included (with 315 cm cable) but you can also use a free app for Android or Apple.

Ledson Commander has a direct input (yellow cable) to be able to control the LED bar/auxiliary lights etc via the vehicle's analogue high beam signal/high beam bulb. Works with 12V / 24V with MosFet / electronic relays, app support for control via Bluetooth, protection against overheating, overload, short circuit and polarity protection.

Included: Commander12 relay box with remote control, battery wiring, fuses, 70 different symbols / stickers to attach to the remote control, bracket with screws for relay box and remote control, assembly instructions.

Do you need a longer cable between the control and relay box? Check out our extension cable, which adds 2.4 meters (giving you a total of 5.5 meters). Also, take a look at our symbol sheet with 38 additional symbols.

More information:

1. Max total current: 100A (1200W at 12V, 2400W at 24V).
2. 12 individually programmable switches.
3. The maximum total current of this device is 100A.
4. Maximum current per output at 12V:
- Output fuses 1 and 5 is 30A - activated when yellow cable receives power
- Output fuses 2, 3, 8 and 9 is 20A
- Output fuses 4, 7, 10 and 11 is 10A
- Output fuses 6 and 12 is 5A
- If the output has been overloaded, a red LED will indicate next to the blown fuse
5. Built-in Bluetooth for app control.
6. Protection against overheating, overload, short circuit, polarity protection.
7. Direct high beam control to circuit 1 and circuit 5.
8. Programmable icons.
9. Backlit switches with selectable backlight color.
10. LED indication for overload/broken fuse.
11. Each switch can be programmed for three different functions:
- Switch between On/Off
- Switch between On/Off as long as the button is pressed
- Strobe function

Measurements on the Control panel:

Length: 116mm
Width: 89mm
Height: 14mm

Relay box: 
Length: 150mm
Width: 117mm
Height: 38mm