Reflector light for Scania 2016+ (xenon white, yellow)

Specially developed light sources to fit in Scania +2016 with LED headlights. The 30 powerful LEDs on each light source illuminate the entire lamp's reflector, giving a very unique effect in an otherwise dark lamp. Available with xenon white and yellow light.

The light sources are a perfect complement to all Scania headlights, whether you have the usual white or yellow light.

The mounting is very simple and the only permanent change required is a single hole that can be easily closed again. The printed circuit board is mounted inside the lamp and secured with two existing screws.

A 3 meter cord on each circuit board can be connected to standard light / side marker.

Mounting

There are two bolts placed near the doors that keep the headlights in place. After unloading, the lamp can be removed.

At the top of the lamp is a large cover that is unscrewed and removed. Below you will find a large heat sink.

Loosen it and remove the two front screws in the heat sink.

The light source is then pushed aside in the lamp so that the two tabs fit with the holes in the heat sink. It is important that the light source is kept above the reflector, otherwise it will not sit optimally. You should not be able to see the circuit board in the lamp when it is mounted.

Insert the two screws into the circuit board and heat sink and tighten.

We recommend that you drill a hole in the back plate of the headlight to guide the cord out. Two PG7 screws are included that fit into a 12.5 mm hole.